YFC 18 Docking SAW

Pneumatic operation of the cutting saw

Available in right hand or left hand operation

Available with roller table assembly (optional)

Photo shows Left hand version

Timber travels from the right side to the left

As shown with push button start cycle.

This means you must push the front buttons at the same time to activate the cutting cycle.

If you remove your hands from either button the saw blade will retract.

PNEUMATICALLY OPERATED UNDER TABLE DOCKING SAW

Specifications

• Available in either right or left hand configuration to suit workflow.
• 455mm (18”) diameter saw blade, travelling up vertically to cut timber, from rest position below worktable.
• Cast iron worktable on fabricated steel base.
• Heavy moving safety guard to strongly clamp the timber to be cut by pneumatic pressure.
• Overhead safety guards 300mm on each side of saw blade.
• Two push button switches on front of machine to commence operation.
• Hinged door on front of machine for easy access to working parts.
• TCT saw blade included, with 120 teeth.
• A well finished, fast and reliable docking saw.

Technical Data

• Maximum section of work piece                                    245mm wide x 108mm high
• (SMALLER WIDTH = GREATER HEIGHT)                  327mm wide x  28mm high
• Saw blade motor                                                           7.5hp, three phase 
• Compressed air consumption                                       11.5 cfm @ 90 psi  (for 45 cycles/minute)
• Dust extraction outlet on side                                       100mm diam (4”)
• Weight                                                                           350 kg